 |
| Logo side of the Miter Saw |
 |
| Back side of the saw plate. |
 |
| Spray down the saw plate with Simple Green and let it soak for a few minutes |
 |
| Scotch-Brite pad and a small off cut of pine. I wrap the pad around the block like a sanding block. |
 |
| Apply elbow grease. It really doesnt take long at all or even a whole lot of effort. Change the pad like you would change sandpaper, they flatten, gum up, and wear out. I have a low tolerance for pulling out a new pad after I use all the spots on the old one. |
 |
| Here I stopped after scrubbing one end for around two minutes to see the difference. |
 |
| You can now make out whats left of an etching you could barely see before. "Made expressly for Goodell-Pratt Company, Toolsmiths, Greenfield - Mass. |
 |
| One side of the saw plate clean. Flip the plate and repeat. Wipe off the remaining cleaner with a cloth. |
 |
| Face side of the plate cleaned up. |
 |
| After the scrubbing is done, I dry off the plate thoroughly, then I lay down a light coat of WD-40 to displace any remaining moisture, wipe that down, then apply a spray coat of beeswax furniture polish, buff that down with a clean fresh cloth and you have a very fresh and clean saw plate. |
0 komentar:
Posting Komentar