As I work through building my own version of Chuck Benders William and Mary bookstand, I am continually blown away with the amount of work that goes on in this little piece. I recall looking at in in the "Arts and Mysteries" section of Popular Woodworking Magazine and thinking to myself, what a cool project to eat up a little stock and a weekend or two. Well I was wrong when I thought that and if I really paid attention, I would have realized that.
I cannot recommend a better workout for an array of basic woodworking skills. For a smallish size piece, its at least an intermediate level build. (I know, I know, dont judge a piece by its size) Just off the top of my head the skill set includes.
Milling pieces to size and thickness.
Through dovetailing.
Proportional layouts with dividers.
Decorative relief cut-outs.
Blind mortise and tenons.
Turning small pieces.
Through mortise and tenons.
Planing for moving elements in a piece.
Complex glue ups.
Careful finishing strategies.
Much more than I originally thought, but so very rewarding in carrying it all out. I suggest you give the piece a try if you havent already. There is a cut list and measured drawing available to download through the Popular Woodworkings Blog HERE. (A word of warning, even though it is revised, it is not without errors, so use it as a guide, but not a bible as you explore this piece yourself.)
At this point I am ready to cut the mortise and tenons holding together the inner frame that will eventually support the book itself. I start by marking out my tenons using a marking gauge. I like to darken the lines in with pencil to help me see them as I cut, especially on this dark walnut.
A small tenon saw cuts on the waste side of the marked lines.
On small tenons like these I take the cut in two stages, I start on the closest corner and saw until I nearly touch the baseline. . .
Then I level the saw and draw the cut down until its level at the baseline on both sides of the stock.
A little chisel work then because its "first class" saw cuts all the way.
With both tenons cut, Im ready to start the mortises. I am unconventional because I cut my tenons first and use them to layout my mortises. I know most people cut mortises first, but this way works for me and garners good results. I stick with it because in the end, its the results that matter.
Using the tenons as a guide, the mortises get marked out.
I learned this trick from Roy Underhill. The piece is so narrow and chopping mortises has the possibility of blowing out the thin sides. With the stock placed in a wood clamp the thin sides are reinforced and blow out is much less likely. I dont always drill my mortises but removing stock to make the mortising easier seemed to make sense this time.
It was off to work with the mortising chisel, some call it a pig sticker, but I cant say that, or type it, without some immature giggling, I know sometimes Im just stuck in middle school mentality.
With the mortises chopped out, I dry fit the frame together. Youll notice the bottom section wider. this gets cut down and sized with the doweling plate to make a pair of 3/8" round pegs. These will be the hinge that the books support turns on.
I mark the drill points for the hinge in the sides of the outer frame. . .
. . . and drilled them out with a brace and a 3/8" spade bit.
Then a dry assembly. Yes I drove my marking awl into my benchtop to make the frame sit up pretty, but its just a benchtop and its meant to take abuse. When its toast, Ill build another. Wait until you see me nail something down to it, then youll really freak out.
Hows this for drama? Next is turning the little bun feet. Ratione et Passionis Oldwolf
0 komentar:
Posting Komentar