Well, Good Friday is a slow day in the OR, as a result I was asked if I wanted to go home a bit early, save the hospital some staffing money, I said hell yes and lit up outta there before the charge nurse could change her mind. See I work on the Orthopedic Surgery Team, and our specialty is usually pretty busy, and we dont get the opportunity to get outta there early very often. When the chance presented, I jumped.
This gave me a chance to finish up on one of the pair of saw horses I have been working on. Just a couple of loose ends to tie up. I started by sawing all the tenon wedges even and cleaning up the glue squeeze out from last night. Then I set to marking out where I wanted the end notch to be. But something was not quite right.
You can see my brilliance went to work once more, when I was cutting my dados I measured my cut on the wrong side of one of the lines. I had used the full length of my tri-square to set the depth of overhang, Obviously I messed up on the one on the right, Now I have to replicate this error when I cut the dados for the other horse so it looks like I meant to do that, Whats that you say? No Im not completely sure why Im mentioning the mistake here if I plan to forever pretend that I meant to do that from this day forward. Ahh such is life.
Then I went to work on the patch where I had the knot knock out while I was chopping the mortises, I was musing on here about a type of wood putty. . . I just didnt really like that idea. As I sat and looked at it this morning I decided a dutchman patch would be just the trick. Im not sure why it didnt occur to me before. Thank god it did now. In the pic below you can see the chiseled out area for the patch and the two pieces of pine I sized to fit the hole. The knot hole looks smaller because it obliterated one corner of the patch area, so I glued and pounded a little chip of scrap into place to even it out . . . a dutchman under a dutchman . . . brilliant!
I do have the one confession here to admit. This horse was supposed to be done with all hand tools, and 99% of it was, in the course of today I discovered that I lack a 3/4 inch brace bit (or I have seriously misplaced it in all the recent moves across the country) either way I had none today to drill the holes for the holdfasts. I did not have the patience today to go to the antique stores in town to try and dig one up, nor did I want to wait for that gem I bought on eBay to show up at the door. I took the bait, chucked a forstner bit into the cordless black and decker drill, and blasted out the holes.
There I feel better with that off my chest.
To finish up I gave the horse a good coat of Danish Oil, and set her off to dry, Like I said one down, one to go.Cheers!
Oldwolf
0 komentar:
Posting Komentar