Heres a question: Whats the best way to deal with end grain?
A. Sand the hell out of it and hope for the best,
B. Take a sharp scraper and scrape the wood fibers clean,
C. Take a sharp gouge and cut the fibers,
D. Wet sand it with mineral spirits,
E. All of the above.
Correct Answer: see below
I took the bowl and remounted it on the lathe and sharpened up my bowl gouge and began to very gently cut away at the surface of the bowl. Doing this should produce very fine wood shavings:
I did this for several minutes and then sanded the surface with 100 grit sandpaper. There was still visible end grain damage:
So I got out my hand drill and attached a sanding disk and sanded it:
That by itself removed some of the end grain but not all of it so Ive wet down the surface with mineral spirits and proceeded to hand sand it and this worked. There is still some end grain damage but not as much. Im going to wet sand the entire bowl and subsequent grits should remove any remaining damage:
Here is the bowl after the 120 grit sanding. You can see a little tear out on the bottom of the photo:
Here is a photo of the bowl at present:
Whew, I thought I was going to have to discard the bowl and start over again.Im going to be sanding and polishing the bowl periodically over the next several days and when Im done with that Ill clean up the shop and vacuum all the dust out of it and get the bowl ready to be varnished.
See you later this weekend,
VW
0 komentar:
Posting Komentar